166
u
u
u
u
u
To check the on/off status of a pixel
[Sketch]
-
[Test]
While the sketch menu is on the screen, press
6
(
g
)
6
(
g
)
4
(Test) and then
input the command shown below to check the status of the specified pixel. 1 is
returned when the pixel is on, and 0 is returned when the pixel is off.
PxlTest <line number>, <column number>
• Specify a line in the range of 1 to 63 and a column in the range of 1 to 127.
• Trying to perform one of the above operations without specifying a line and
column number results in an error.
• Pixel operations are valid only within the allowable line and column ranges.
k
k
k
k
k
Clearing Drawn Lines and Points
[Sketch]
-
[Cls]
The following operation clears all drawn lines and points from the screen.
u
u
u
u
u
To clear lines and points in the STAT, GRAPH, TABLE, RECUR and
CONICS Modes
Lines and points drawn using sketch menu functions are temporary. Display the
sketch menu and press
1
(Cls) to clear drawn lines and points, leaving only the
original graph.
u
u
u
u
u
To clear drawn lines and points in the RUN or PRGM Mode
The following is the syntax for clearing drawn lines and points, as well as the
graph itself.
Cls EXE
10 - 2
Graphing with the Sketch Function
Summary of Contents for CFX-9970G
