20021201
(7) After saving the program, tap
)
, or tap
O
and then [Program Loader] to display the
Program Loader window.
(8) On the dialog box that appears, tap the [Name] down arrow button, and then tap the
name of the file you input in step (6) (TETRA).
(9) Tap
p
, or tap [Run] and then [Run Program].
• This runs the program.
(10) Input 7 for the length of side A and tap [OK] twice.
7 [OK] [OK]
(11) Repeat steps (9) and (10) for sides of length 10 and 15.
p
10 [OK] [OK]
p
15 [OK] [OK]
12-3-4
Debugging a Program
Tip
• To edit a program and save it without running it, perform the above procedure up to step (7), and
then tap [Edit] and then [Close File]. If the “WARNING! Save changes?” dialog box appears,
perform one of the operations described below.
Save and close the program
Yes
Close the program without saving
No
Return to the Program Editor window without saving the program
Cancel
Tap this button:
To do this:
Tapping [Yes] or [No] causes the message “No File” to appear on the display.
20030201
