E-56
Using the Bridge Satellite Cradle (HA-A61IO)/Bridge Basic Cradle (HA-A60IO)
4. Hook the upper wall mount unit hole onto
the upper screw.
5. Drive the other screw into the wall at the
location where the lower hole is located.
6. Drive the upper screw and lower screw
into the wall the rest of the way.
To remove the Bridge Satellite Cradle/Bridge Basic Cradle from the
wall
1. Loosen the upper screw and lower screw.
2. Raise the Bridge Satellite Cradle/Bridge Basic Cradle and remove it from the screws.
Important!
•
While the Bridge Satellite Cradle/Bridge Basic Cradle is mounted on a wall, be
sure to check the wall screws periodically for looseness. Tighten them as required.
•
Note use of the RS-232C cable is not supported by the wall-mounted
configuration. Connect using a USB cable or daisy chain cable.
DT-X5_E_P49_58.p65
2004.10.1, 9:49 AM
56
Summary of Contents for DT-X5 Series
Page 71: ...E 69 Memo...
Page 72: ...E 70 Memo...
