93
List Function
Chapter 6
u
u
u
u
u
To input a value into a specific cell
You can input a value into a specific cell inside a list. When you do, the value that
was previously stored in the cell is replaced with the new value you input.
Example
To input the value 25 into cell 2 of List 3
cf
a
K
1
(LIST)
1
(List)
d
!
[c
!
]
w
k
k
k
k
k
Recalling List Contents
Example
To recall the contents of List 1
K
1
(LIST)
1
(List)
b
w
• The above operation displays the contents of the list you specify and stores them
in Ans Memory, which allows you to use the Ans Memory contents in a calcula-
tion.
u
u
u
u
u
To use list contents in Ans Memory in a calculation
Example
To multiply the list contents in Ans Memory by 36
K
1
(LIST)
1
(List)
!K
*dg
w
• The operation
K
1
(LIST)
1
(List)
!
K
recalls Ans Memory contents.
• This operation replaces current Ans Memory contents with the result of the above
calculation.
k
k
k
k
k
Graphing a Function Using a List
When using the graphing functions of this calculator, you can input a function such
as Y1 = List1 X. If List 1 is {1,2,3}, this function will produces three graphs: Y = X, Y =
2X, Y = 3X.
There are certain limitations on using lists with graphing functions.
k
k
k
k
k
Inputting Scientific Calculations into a List
You can use the numeric table generation functions in the Table Mode to input values
that result from certain scientific function calculations into a list. To do this, first gen-
erate a table. Next, use the “list copy” function to copy the values from the table to the
list.
P.78
Summary of Contents for fx-7400G PLUS
