29
Basic Calculations
Chapter 2
u
u
u
u
u
To set the default angle unit
Example
To change the angle unit from radians to degrees
!Z
cc
1
(Deg)
• Once you change the angle unit setting, it remains in effect until you change it
again using the set up screen. You also should check the set up screen to find out
what the current angle unit setting is.
k
k
k
k
k
Converting Between Angle Units
You can use the following procedure to input a value using an angle unit that is not
the current default angle unit. Then when you press
w
, the value will be converted
to the default angle unit.
u
u
u
u
u
To convert between angle units
Example
To convert 4.25 radians to degrees while degrees are set as the
default angle unit
A
e.cf
K[
2
(ANGL)
2
(
r
)
w
1
2
3
4
1
2
3
4
1
2
3
4
Summary of Contents for fx-7400G PLUS
