20051101
2-9
Using the Setup Wizard
7. Press
6
(DRAW) to graph the function.
• This graphs the function and displays a vertical cursor line as shown below. Use the
graph to specify the range that you want to output to the speaker.
8. Use the
d
and
e
cursor keys to move the cursor to the start point of the output, and
then press
w
to register it.
9. Use the
d
and
e
cursor keys to move the cursor to the end point of the output, and
then press
w
to register it.
• After you specify the start point and end point, an output frequency dialog box shown
below appears on the display.
10. Input a percent value for the output frequency value you want.
• To output the original sound as-is, specify 100%. To raise the original sound by one octave,
input a value of 200%. To lower the original sound by one octave, input a value of 50%.
11. After inputting an output frequency value, press
w
.
• This outputs the waveform between the start point and end point from the EA-200 speaker.
• If the sound you configured cannot be output for some reason, the message “Range
Error” will appear. If this happens, press
J
to scroll back through the previous setting
screens and change the setup as required.
12. To terminate sound output, press the EA-200 [START/STOP] key.
13. Press
w
.
• This displays a screen like the one shown below.
/
Summary of Contents for FX-7400GII
Page 337: ...E CON2 Application ...
