E-35
1. Hold down Fn key and CLR key while pushing down the reset switch for about 3
seconds with the tip of a stylus until the message shown below appears on the display.
To cancel the full reset operation, press L Trigger key on the scan engine integrated
models or L Enter key on the non-scan engine integrated models.
Message appeared on the scan engine integrated models.
R Trigger key (For
scan engine
integrated models)
R Enter key (For
non-scan engine
integrated models)
Message appeared on the non-scan engine integrated models.
2. Press R Trigger key on the scan engine integrated models or R Enter key on the non-
scan engine integrated models. This causes the message shown below to appear.
To cancel the full reset operation, press L Trigger key on the scan engine integrated
models or L Enter key on the non-scan engine integrated models.
Message appeared on the scan engine integrated models.
R Trigger key (For
scan engine
integrated models)
R Enter key (For
non-scan engine
integrated models)
Message appeared on the non-scan engine integrated models.
3. Press R Trigger key or R Enter key again to perform the full reset.
The full reset starts and all data in the memory are erased, and the start-up screen
appears.
Data stored in the Flashdisk folder remain unaffected.
•
•
•
