E-49
Important !
Always make sure to first remove the IT-G500 from the Cradle when switching
the selector switch.
Water or other liquids on the data communication or power supply terminals
can lead to an electric shock or fire. Note also that soiling on the terminals will
impair the connection, leading to reduced power supply and communication
functionality. As a safety precaution, disconnect the AC adapter before wiping
the data communication and power supply terminals clean with a dry cloth or
cotton bud.
Never short out the power contacts of the Cradle. This can damage the Cradle.
Note that subjecting the Cradle or cradle-type battery charger to impacts or
strong vibration could dislodge the Handheld Terminal. Also avoid any vibration
or impacts during communication with a LAN, USB client or USB host, as this
can cause communication to be interrupted.
When loading the IT-G500, fit it securely in place and check that the green
power indicator LED on the front of the Cradle is lit. The IT-G500 must be
inserted correctly to draw power and communicate successfully.
Always cap ports that are not being used. Using the Cradle while the ports are
uncapped can cause damage.
Do not pick up the IT-G500 while it is mounted in the Cradle. Doing so may
result in the Cradle being accidentally dropped, causing injury or damage.
If the Cradle will not be used for an extended period, set the power switch to
OFF.
Place the Cradle or cradle-type battery charger on a flat, level surface and take
care when placing the IT-G500 in or removing it from the cradle.
The microUSB port on the Handheld Terminal cannot be used while the
terminal is set in the Cradle.
Ethernet Cradle Specifications (HA-P62IO)
1. LAN Specifications
Communications protocol: IEEE 802.3
Media type:
10base-T/100base-TX auto-switched
2. USB
Protocol:
USB Ver2.0 Full speed
Transmission Rate:
12Mbps (max.)
3. Charging
Charging Method:
Constant current/voltage (the charging circuit is built in
IT-G500)
Charge Period:
Approximately 4 hours (battery pack)
Approximately 7 hours (large-capacity battery pack)
4. Power Supply
Power Source:
AC adaptor (AD-S42120C)
Consumption Current:
12V DC approximately 3.0A
Output to Handheld Terminal: 5V DC 3.0A (max.)
USB Host Output:
5V DC 0.5A (max.)
•
•
•
•
•
•
•
•
•
•
