107
C
h
ap
t
e
r
8
E
-Ma
i
l
a
n
d
S
M
S
•
Outbox shows only the mail to be sent through the currently selected access
point. Mail to be sent through other access points is not shown.
•
If you do not input your login password into the LOGIN PASSWORD field
when setting up your access point (page 97), the PV Unit will prompt you to
input it each time you try to send mail. When the password prompt appears,
input the correct login password and then tap the
Set
button in the toolbar. To
cancel the send operation, tap
Esc
.
Sending All Unsent Messages
You can send all unsent messages currently in the
Outbox
tab either by
using the
Send
button at the top of a screen or by tapping the
Send
button
on the initial Mail Mode screen.
•
You can also sent all the unsent messages by tapping
Send
on the Action
Menu. Tapping
Send & Receive
on the Action Menu sends queued
messages and picks up any mail waiting on the server.
To send all unsent messages with the tool bar Send button
1. Tap the
Send
button in the tool bar at the top of the screen.
2. On the menu that appears, tap
Send all
.
3. In response to the confirmation message that appears, tap
Yes
to send all
unsent messages or
No
to abort the procedure without sending anything.
•
If you tap
Yes
, the PV Unit initializes the modem, dials the number of
the currently selected access point, logs in to the host computer, sends
the mail messages, and then disconnects.
•
Tapping
Esc
during the above sequence cancels the connection and send
operation.
To send all unsent messages from the Mail Mode initial screen
1. While the Mail Mode initial screen is on the display, tap the
Send
button.
2. In response to the confirmation message that appears, tap
Yes
to send all
unsent messages or
No
to abort the procedure without sending anything.