— 6 —
3-2 Adjustment B
1.
Remove the stop ring and idol gear as shown in Fig. 1-5.
2.
Move the motor gear the equivalent of one tooth. Reattach the idol gear and stop ring. The position-
ing of the motor gear in relation to the idol gear is illustrated in Fig. 1-6 (refer to the placement of the
and symbols). (Make sure that the
and symbols are not aligned.)
*If the print generated from right to left is off to the right, rotate the motor gear in the direction indi-
cated by the arrow.
3.
Return to section 3-1 and repeat Adjustment A.
Motor gear
Idol gear
Print generated from left to right (outwards) H H H · · · H
Print generated from right to left (inwards)
H H H · · · H
Fig. 1-6 Adjustment B for dot alignment
Summary of Contents for SP-1300
