V-R100
– 33 –
6. Drawer #1 and #2
[Function]
Tests drawers.
[Note]
There are two types of drawer cables. Long cable is for drawer 1 and short cable for drawer 2.
[Procedure]
(1) Connect the drawers 1 and 2 to the corresponding cables.
(2) Touch "6" on the display panel.
(3) Make sure that the drawer 1 opens automatically.
(4) Close the drawer 1.
(5) Make sure that the drawer 2 opens automatically.
(6) Close the drawer 2 or press the “INIT” switch, and return to the IOC MENU.
7. Printer
[Function]
Tests the built-in printer.
[Procedure]
(1) Touch "7" on the display panel.
(2) Print the test page as shown below and cut the printout.
(3) Check if all the printings are correct.
B: 2 lines
Dots: 8 lines
Single-byte characters: 2 lines
Double-byte characters: 2 lines
25% gray: 6 lines
100% black: 6 lines
Summary of Contents for V-R100
