1
WARNING
NEVER LEAVE YOUR FOOT
ON THE PEDAL DURING ADJUSTMENT OPERATIONS
NOR YOUR HANDS
UNDER KNIVES OR CHIP SECTION
PUTTING INTO OPERATION
1)
Fittings
- 1 x 17 mm monkey wrench
- 1 x 15 mm Allen wrench.
2)
Table extension assembly
3)
Cleaning
After table extension is assembled, clean the machine with a petroleum impregnated mob or swab to
dissolve the rust preventive.
4)
How to use the machine
Cutting operation : never remove the protective screen
Before every cutting operation bring the protective screen as near as possible to the moulding to cut.
Before pressing down and releasing the pedal, never forget to put the two hands on both sides of the
shielding caps, on the moulding, far from the knives in order to get a sustained pressure on the
moulding while maintaining rabbet ( rebate ) holders.
Make sure the both sides coming into contact are
cleaned, especially in place of the two pins and of the
threaded hole so that the table extension lies level with
the table.
The presence of coarse dust particles should result in a
faulty positioning of the extension table compared to the
table.
