Non contractual document - Cassese France
®
- Document non contractuel
4
Put the first moulding in front of the back fence
1
and slide the moulding in
contact with the 2nd back fence
2
.
Setting up the stapling position
close to the outside of the frame :
Move forward the sliding table
E
until the
place where you want to insert the wedge(s)
has been reached by the
WEDGE EXIT
(see
picture). Then bring the wedge position
stop handle
6
against the stapling stop
10
and tighten it.
Setting up the stapling position
close to the inside of the frame :
Move backwards the sliding table
E
until
you have reached the furthest position to
the inside of the frame where you want to
insert wedge(s).
Then bring the wedge position stop handle
5
against the stapling stop
10
and tighten it.
Now the two positions of joining are
set and the sliding table can move only
within the limits of these two positions.
WEDGE
EXIT
E
10
6
10
5
Wedges between
the first and the
last position
1
st
position
Last
position
2
1
2
1
Summary of Contents for CS1 CART
