NOR INS REV 5 Nov 2017
Door handle adjustment
The door handle has a sophisticated adjustment system. The door handle
comprises of only 4 parts and can be adjusted very simply by the end user.
The system allows adjustment without the need for spanners or other tools.
The stove is provided with a set screw to perform this function, keep this safe.
The door rope over time will flatten and the door seal will start to let air into the
stove, this will allow unwanted air into the combustion and increase the speed
of the burn and controllability of the stove.
Using the supplied Allen key, insert it into the hole in the side in the side of
door containing the set screw. Turning the anti-clockwise slacken the set screw
until the door handle becomes loose, once loose turn the handle the correct
way as per below drawing below, on completion slowly re-tighten the setscrew
until the handle is set.
Flue test point
Your Norvik stove has a flue test point, the function of the test point has
various functions.
•
Correct instillation, aiding the installer to set up the Norvik with the flue
pull matching the manufacturers recommendations
•
Measuring the flue pull to check for soot or tar build up in the chimney
Flue test position
Your Norvik stove test point is situated discreetly at the rear right hand side of
the stove. The M8 screw is removed and a flue test meter is placed in the hole
to measure the flue pull. On completion the M8 screw is re-fitted.
Insert Allen key
Flue test point
