8
Fig.5
Fig.6
Fig.7
Fig.8-
a
3.3
Installation
⚫
Move the column C and arm D, put them on a soft
cushion.(Fig.5)
NOTE
：
When you lift the column, the arm D will fall freely, be
careful!
NOTE
：
ZH650 has two different size of packing, if it is
97x75x95mm, plz refer to Appendix 3 page30,
the Drawing of installation for small package.
You have to install part No. 2, 3, 4, 5, and turn
around 90 degree of part No.1 as the drawing.
3.3.1 Install return spring
⚫
Use 6mm inner hexagon spanner to take off the screw
H which is inside of the plastic cover B. Take
Quadrate column E out, move the spring A, then
install hex column back. Put the spring A on the top of
hex column and install the plastic cover B back and
tighten screw. (Fig.6)
3.3.2 Install the column
⚫
Use 6mm inner hexagon spanner to take off the screw
B and washer C, then take off the side cover A and
cover as fig.7.
⚫
Lift column E as fig.7 , make pin hole of column and
body in line, insert pin axis H, tighten screw F and
washer G (screw M12x25)
（
If column can not be
fixed in, loose screw M, after installation finished,
tighten screw M again.
）
.
⚫
Tilt column, make hoseφ4 M through hole O in the
body N (Fig. 8).
NOTE
：
Before hoseφ4 O come through pin hole of column, make
sureφ4 hose O begins at the back of pin L to avoid hose
damaged.
⚫
Pull column forward slowly, when the hole in column
and piston rod I in line, insert pin axis J, use washer
and screw J to fix.(M12x55,fasten M12 screw K) .
⚫
Make column straight, finish column installation.
Summary of Contents for CASC506
