OPERATION
TS--2700/TS--3300 (05--04)
10
CIRCUIT BREAKERS
The machine is equipped with (4) circuit breakers to
protect motors from damage. If circuit breakers should
trip, they cannot be reset immediately. Determine
cause, allow motor to cool and then reset. The brush
motor circuit breakers (35A), located near charger
plug, will trip due to excessive overload on pad. Turn
over or change pads if breakers should trip. The main
circuit breaker (10A) and vacuum/drive motor circuit
breaker (35A) are located at rear of machine
(Figure 15).
FIG. 15
DRAINING TANKS
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
DRAINING RECOVERY TANK
Recovery tank must be emptied prior to refilling
solution tank. To drain recovery tank, perform the
following steps:
ATTENTION: If recovery tank is not emptied
between fill--ups, foam or water will enter float
shut--off screen located in the recovery tank and
damage vacuum motor. Float shut--off screen will
not keep foam out. Vacuum damage due to foam
or water is not covered by warranty.
1. Remove recovery tank drain hose from holder,
position hose over floor drain and twist off cap.
To completely drain recovery tank, hinge open
tank sideways and flip up tank support stand to
rest tank on (Figure 16).
NOTE:
If using a bucket to drain machine, do not use
same bucket for filling solution tank. This will prevent
possible solution line clogs.
FIG. 16
2. Rinse out recovery tank after each use. This will
prevent foul odor buildup. Use a hose to rinse out
the recovery tank. Be careful not to spray water
into shut--off float screen.
3. Replace drain hose cap tightly after draining.
DRAINING SOLUTION TANK
1. Pull solution tank drain hose (clear hose) off hose
barb at rear of machine and drain solution into
floor drain or bucket (Figure 17).
FIG. 17
2. Rinse out solution tank with clean water after each
use and flush out solution flow system. This will
prevent clogging due to chemical buildup. Use
clear hose to drain solution tank.
3. Reconnect clear hose to hose barb. Be certain
hose is completely pushed onto hose barb.