OPERATION
TS--2700/TS--3300 (05--04)
8
6. Attach brush/pad drivers to motor hubs. Align (3)
mounting studs with slots in motor hub. Give driver
a quick turn toward spring clip located on motor
hub. Be certain pad driver is securely fastened
and spring clip locks into one of the studs before
operating machine (Figure 8).
FIG. 8
NOTE:
Always make sure pad driver and motor hub
surfaces are clean before installing drivers. Keeping
surfaces clean will make it easier when removing pad
drivers.
7. Close skirt housing and refasten latch.
FILLING SOLUTION TANK
1. Transport machine to filling station. Raise
squeegee and scrub head when transporting.
2. Turn off machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
3. Open solution fill door on side of machine and fill
solution tank with clean water, 60
°
C (140
°
F)
maximum temperature. Or you can fill solution
tank using hose fill port at rear of machine. Pull off
plug and insert hose to fill. The clear tube below
the fill port has 19L (5 gallon) increment markers
to indicate amount of water in tank (Figure 9).
FIG. 9
NOTE:
The water must
not
be hotter than 60
_
C
(140
_
F) or tank damage may occur.
NOTE:
If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
4. Add cleaning chemical. See proper dilution ratio
instructions on bottle.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: Use only recommended detergents.
Machine damage due to improper detergent usage
will void the manufacturer’s warranty. Contact
your sales representative for detergent
recommendations.
WARNING: Fire Or Explosion Hazard. Never
Use Flammable Liquids.
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Slide squeegee lever to the left to lower squeegee
assembly (Figure 10)
.
FIG. 10
2. Push top foot pedal forward to lower scrub head
(Figure 11).
FIG. 11
