CONTROL PANEL & DISPLAY
CONTROL PANEL
DISPLAY
OPERATING INSTRUCTIONS
NOTE:
It is normal when the heaters are turned on for the first time or when they are turned on after
having not been used for a long period of time, the heaters may emit some smell and fumes. This will
disappear when the heater has been on a short while.
WARNING:
The surface around the heating element gets hot during operation.
DO NOT TOUCH
the
surface while accessing the control panel.
MANUAL OPERATION
1.
Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area
matches that on the rating label on the unit. Plug the heater into a wall socket once this matches.
2.
Place the heater on a flat, smooth and firm surface. If on carpet, ensure that the carpet does not
obstruct the air vents on the underside of the body.
3.
Press the power ON/OFF switch on the side of the machine to the ON position, the program will
initiate after the buzzer beeps. On the display board, the WIFI
(icon will be flashing) and
temperature icon
will be shown.
DISPLAY
LOW TEMPERATURE
(NR10 500W / NR15 750W /
NR20 1000W)
HIGH TEMPERATURE
(NR10 1000W / NR15 1500W
/ NR20 2000W)
ANTI FROST MODE
TIME
POWER
INCREASE
SETTINGS
DECREASE
SETTINGS
