14
Revision Date: 4/7/12
breaker for the windlass, located just forward of the navigation table, must be pushed in.
A red light
will illuminate when the breaker is in all the way. The windless is only intended for use with the rode. The
chain must be pulled by hand.
Setting the anchor:
Let out sufficient anchor rode (chain and line) before setting the anchor. Color markers are placed every 30
feet on the chain and nylon rode. If the anchorage is crowded, put down at least a 3 to 1 scope (60 feet of
rode for 20 feet of water at highest tide). Back the anchor in with a short burst in reverse from the engine.
Then let out additional scope dependent upon conditions. If the anchorage is less crowded, more scope is
always a better option. The holding power of the anchor increases greatly as more scope is added. There is
a second anchor stowed in the forward chain locker.
Raising the anchor:
Coordinate the maneuver with the helmsperson to remain steady above the anchor as it is raised. As the
anchor rises, be careful not to allow it to swing against the hull.
Summary of Contents for 1999 Catalina 34 MK II
Page 7: ...7 Revision Date 4 7 12 ...