STEP 3
Parts Required:
Quantity
Part Description
8
Plastic Spacer (Black plastic M3 hole x 7mm OD x 2mm long)
4
Hex Standoff 'Male – Female' (Black plastic M3 thread x 6mm long)
4
Phillips Head Screw (Black plastic M3 thread x 12mm long)
1
Power Distribution Board
*
Not included and sold separately
*
Assembly Process:
Install the PDB onto the main base plate as pictured below. Make sure the screws are tight into the standoffs, however
do not over torque. Keep in mind these fasteners are nylon which is a soft material. Don't strip the standoffs. The PDB's
main lipo pigtail should exit the rear of the craft. There are two slots machined into this area. Run a zip tie through the
slots and around the lipo pigtail. This is an important stress relief for the pigtail. File down the edge of the carbon fiber
on the main base plate which comes into contact with the lipo pigtail wires.
Summary of Contents for Speed Addict SuperLight
