STEP 5
Parts Required:
Quantity
Part Description
1
RX Antenna Mount (3D Printed TPU)
2
Antenna Tube (Red Plastic)
1
RX Radio receiver *
Not included and sold separately
*
1
VTX Antenna Mount (3D Printed TPU)
Assembly Process:
Install the RX antenna mount onto the two rear standoffs as shown below. Make sure the pigtail 'cut-out' faces toward
the lipo pigtail. Install the two antenna tubes as shown. At this point you can choose to install the RX radio receiver.
Thread it's antenna wires through the antenna tubes and then mount the receiver to the top of the FC using some
double sided stick tape. You can also use a small zip tie to secure the receiver in place by wrapping it around the
FC/receiver. Do not over tighten the zip tie or you may damage components. The zip tie only needs to be snug. Install
the VTX Antenna Mount as shown.
Summary of Contents for Speed Addict SuperLight
