27 - 40
021774/07/14
6.3.4 Command DC
<id>DC<parameter><CR> Mode of calculation for twilight
Access:
Read/ write
Description:
The mode of calculation for twilight is stated by command DC. The
twilight is calculated from the 4 brightness values, depending on direction.
Here, one can select between sum and mean value.
Parameter description:
0: Twilight corresponds to the sum of the 4 brightness values
1: Twilight corresponds to the mean value of the 4 brightness values
value rang:
0...1
Initial value:
0
6.3.5 Command DO
<id>DO<parameter><CR> North correction of wind direction
Access:
Read / write
Description:
The command DO is used to specify an offset for the wind direction
in °. This brings about correction to the north for the Weather Station.
Value range:
0…360
Initial value:
0
6.3.6 Command FB
<id>FB<parameter><CR>
Quick-start mode
Access:
Read / write
Description:
The command FB is used to select quick-start mode.
Parameter description:
0: quick-start mode disabled
1: quick-start mode enabled
Value range:
0...1
Initial value:
1
6.3.7 Command ID
<id>ID<parameter><CR>
Identification number
Access:
Read / write
Description:
This command is used to specify the identification number (THIES
interpreter) resp. the slave address (MODBUS RTU Interpreter). A
response telegram will only be transmitted if the 'id' in the command
matches the one set in the Weather Station. An exception here is the
generic 'id' that causes all weather stations to respond. Once the 'id' has
been changed, the device will immediately respond with the new 'id'.
