25
6.1.3.
Headrest height adjustment
Stair-climbing wheelchairs is equipped with adjustable headrests.
Adjustment of the headrest in height is carried out as follows: you must
simultaneously press the plastic clips of the rails (left and right), set the
height, release the clips (fig.6.3). If the clips does not fit into the groove
of the rail, you should make a slight adjustment to the position of the
headrest (move up or down to the nearest groove to fix the position).
To remove the headrest, after pressing the clips, it must be pulled up
until removed.
Fig. 6.3.
Headrest height adjustment
6.1.4.
Adjusting the position of the remote control
Cable damage.
Improper cable routing can damage the cable. When
routing, the cable should not be sagged or overstretched. Bends and
clamps must also be avoided.
Removing the remote controller
You can remove the remote controller by unscrewing the thumbscrew
located on the backside of the remote controller (fig.6.4 position 1)
To do this, it is necessary to make several turns of the thumbscrew until
the console begins to move freely in the seat. Then apply slight pressure
to the front and pull it forward. If the remote controller is not removed
after that, then you should make one more turn of the thumbscrew and
try again.
Another way to remove the remote controller is to completely unscrew
the thumbscrew.
In this case, the remote control is removed without
additional manipulation. Remember that the thumbscrew will need to be
screwed back in to install the remote controller back.
Before removing the remote controller, make sure that the wire is long
enough for free removal and that it can move freely. Otherwise, there is
a possibility of damage to the cable.
