21
5.
Transport and storage
5.1.
Preparing for transportation
To transport the Product in the trunk of a vehicle or airplane, you need
to prepare it for transportation.
Remove the footrests. Press the lever at the base of the footrest
to the chair frame and pull up (see fig. 6.6).
Fold the seat into the transport position, pull the lever up, then
tilt the backrest forward (see fig. 5.1).
If the armrests are raised high, they can be lowered. To do this,
unscrew the fixing bolts (see Cig. 6.2).
If the
Product
is to be transported in the aircraft luggage space,
the drive wheels should be set to idle mode (see fig. 7.13).
If the Product is supposed to be transported in the luggage
compartment of the aircraft, the drive wheels should be set to
idle mode (Fig. 7.13). For the GTS 4WD model, you must select
the rear-wheel drive mode.
If the
Product
will be transported in the trunk of a personal car, it
can be loaded into it along the ramps. Depending on the design
of the ramps, the
Product
can independently enter the trunk on
wheels or tracks.
To avoid damaging the remote control, remove it from the holder
and place it on the seat.
Turn off the Product by turning the automatic switch to the off
position (see fig. 4.3).
Fig. 5.1.
Folding the backrest to the transport state
