11
2.8
Turning on/off and operating
1.
Make sure the ESD button is pressed. If it is not - push it to activate the wheelchair.
2.
Press the On/Off button to turn on the wheelchair
WARNING
Make sure that all other buttons are not pressed and the joystick is not
inclined before turning on the wheelchair. Otherwise the wheelchair turns off
automatically.
3.
After 1 second of loading the wheelchair can be operated. The wheelchair is in safe mode
until any button or joystick activated. To start driving incline the joystick in direction of
driving. To stop driving release the joystick. To start execution of other commands press
necessary button.
4.
Press the On/Off button one more time to turn the wheelchair off when finished.
NOTICE
There is no need to press ESD button to turn off the wheelchair during normal
operations. Press the ESD button for emergency stop only.
3.
Maintenance Manual
3.1
Cleaning and Care
WARNING
Do not use
any aggressive cleansing agents, solvents, or hard brushes for
cleaning the power wheelchair. Never use a water jet or high-pressure cleaning apparatus
for cleaning the power wheelchair.
Prior to disinfection, clean the seat and back upholstery as well as the seat cushion, the control
panel and the armrest.
3.2
Changing the Fuse
The 40 A fuse is located in a fuse holder in the front section of the battery case (see fig. 9).
Open the cap of the safety holder and exchange the fuse. Make sure that the fuse is pressed into
the center of the spring contacts and that it is not at an angle. Close the cap until you feel it snap back
into place.
1
2 3
Fig. 9
