-21-
When assembling for the first time, be sure to
remove all packaging from the components
prior to beginning assembly.
1. Install threaded poles into triangular base as
shown in Figure 1. Be sure to seat poles fully
inside base.
2. Install lower legs by pressing push tab relea-
se and inserting into upper pole (see Figure). Be
sure push button is locked in place.
3. Install 3 feet to lower legs as shown in Figure.
Be sure to tighten wing bolt after installation.
4. Install tank straps to LPG cylinder as shown in
Figure 4. Length of strap from tank flange to end
of clip should be between 20-25cm from tank
flange. This should maintain a 5cm minimum
clearance from bottom of LPG tank to ground.
5. Install tank straps to base as (see Figure).
6. Install tank restraint to tank and fasten
restraint straps around legs as shown in Figure.
ASSEMBLY
E
