Cavaliere 218 Series, Installation Manual And User'S Manual

Preparation

Page 9

Advanced Preparations:

Be familiar with the controls of the range hood by reading 

1. 

through 

Range Hood Operations,

 Page 12.

Place the range hood on a flat, stable surface. Connect the 

2. 

range hood to a designated standard outlet, 110~120V/60Hz 

(220~240V/50Hz for Europe & other countries), AC only 

and turn on the range hood. Verify all operations of the 

range hood by referring to 

Range Hood Operations, 

Page 

12.

Place all supplied parts and required hardware on a flat, stable surface and verify the existence of all sup

-

3. 

plied parts listed on Page 4.

Carefully remove the white plastic protective coat from the chimney covers and range hood.

4. 

Preparations:

Determine and mark the center line on the ceiling where the range hood will be installed. Make sure there is 

1. 

proper clearance within the ceiling or wall for exhaust vent.

Due to the weight and size of this unit, please make sure that the support system or framework being used is 

2. 

stable and secure in the wall.

Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt. Remove 

3. 

any hazardous objects around the area when installing.

Mark the locations of the support mounting bracket holes, vent cutout (if used) and power supply cable cut

-

4. 

out on the ceiling. Use drill and saber saw or keyhole saw to cut openings for power supply cable and vent 

(see 

Venting Methods

 and 

Electrical requirements

, Pages 7-8).

If venting to the outside install vent system (see 

5. 

Venting Requirements

, Page 5). Use caulking to seal exte

-

rior wall or roof openings.

Disconnect main electrical supply, prepare and run electrical wiring through ceiling or wall. Leave approxi

-

6. 

mately 12” of electrical cord hanging from the ceiling. Do not restore power until wiring is completed.

Disconnect power cord, remove the stainless steel baffle filters by pulling down toward the direction of solid 

7. 

arrow while holding both of the metal handles, gently pull the stainless steel baffle filters toward the direc

-

tion of dashed arrow as shown in Figure 1 and the grease tunnel.

Remove the grease cup by sliding it sideway, see Figure 2 for location of the grease cup.

8. 

Set aside the stainless steel baffle filters, grease tunnel and grease cup until the range hood is properly in

-

9. 

stalled.

If the range hood comes with a glass canopy and has not already been mounted to the hood, loosen the four 

10. 

canopy screws and washers from the hood top, carefully place the canopy on the hood top, and loosely tighten 

the four canopy screws along with washers. DO NOT put excessive pressure against the glass.

Excessive Weight

Require three or more person to move and 

install this range hood. Spinal or other bodi-

ly injuries could occur if it is not followed.

WARNING

WARNING

Severe Injury

Rotating fan can cause severe 

injury.  Stay  clear  of  fan  when 

motor is running.

Figure 2

Figure 1