Diesel Engine Service
The diesel engine requires routine maintenance. Oil must be checked and changed
regularly. Oil, air and fuel filters must be checked and changed regularly. The engine
crankcase holds 1.35 gal (5.1 L) and the oil filter an additional 10 oz. (0.3 L) of SAE
10W40 viscosity lubricating oil. For detailed information on these routine maintenance
requirements as well as other service recommendations, see the engine manufacturer’s
literature found in the
APPENDIX
.
Pump Service
The high pressure water pump requires minimal maintenance. The pump oil should be
checked on a regular basis. The pump crankcase holds 44 oz. (1.3 L) of SAE 30
viscosity non-detergent hydraulic oil. See pump manufacturer’s literature found in the
APPENDIX
for further information.
Inspection/Cleaning of Water Inlet Strainer
The water inlet strainer should be inspected after each use of the CaviBlaster
®
1325-D.
To inspect and clean this strainer, follow the procedure below:
1)
Isolate or disconnect the water source from the inlet connection to the power unit.
2)
Unscrew the filter housing (turn CCW) (See Figure 6.1).
3)
Pull filter bowl off.
4)
Remove the strainer.
5)
Inspect the strainer and flush any debris clean with clean water.
6)
Push strainer back into housing.
7)
Push the bowl back into filter housing.
8)
Thread the housing nut CW by hand to tighten.
Page - 34
CaviBlaster 1325-D Operations Manual
For More information please email sales@cavidyne.com or call 1-(352)275-5319