Page 25/43
For more information please email sales@cavidyne.com or call 1-(352)275-5319
trigger on the DoubleDome and submerse the DoubleDome before
starting the engine.
5) Start up the power unit as described in section 5.2.
6) Throttle the engine up by completely pulling the black throttle cable knob
all the way out and twisting the knob to lock it (See Figure 5.1).
7) Activate the cleaning cavitation stream by squeezing the trigger to the
open or “ON” position (See Figure 5.3). Release trigger to stop the water
flow and direct to dump or bypass. Open the ball valve on the
DoubleDome to start the nozzles rotating, close the ball valve to stop the
nozzle rotation. Engine must be at full throttle for nozzles to function.
8) If the diver operating the unit must be replaced or the cleaning operation
must be interrupted or terminated, disengage the pressure pump by
pushing the throttle lever in to the idle position and turning the ignition key
to the “OFF” position. (See Figure 5.1)
Then release the water pressure in
the hose(s) by squeezing the gun trigger to the open or
“ON” position (See
Figure 5.3)
while under water
.
Revert back to step 3 of the operating
instructions when the diver or replacement is ready to continue cleaning.
9) After the engine has shut down, close the ball valve on the DoubleDome
to ensure that the nozzles are not rotating.
Although the CaviBlaster
®
system is safe to use when
submerged in water, the system generates a high-pressure
(up to 2,800-psi [193 BAR]) water stream, which can cause
injury when the gun(s) are out of the water. ALWAYS keep
the gun submerged when the engine is running.
