Stage 4 - Fit Lock and Furniture
Fit lock into mortice and screw in place using
#10 countersunk screws supplied.
1. Locking pin should be 0.5mm (1/64”) shorter
than door thickness. Cut to suit if required
and de-burr the end.
Emergency
release
button
2. Cut Lever & Rose handle screws to 19mm (3/4”)
larger than door thickness.
3. Refit faceplate.
4. Fit locking buttons with springs.
5. Check handing and hold indicator plates in place
while fitting spindle and handles. Tighten screws
enough to hold handles in place.
6. Test lock for the following:
A - Handles move freely.
B - Latch returns to the latched position when
handle is let go.
C - Locking buttons move freely without jamming.
7. Line the face plates up to be parallel to the door
edge.
8. Fully tighten handles to door.
9. Drill holes for indicator plates and screw to door.
Stage 5 - Fit Striker
1. Slide door closed and transfer height line
from door onto closing jamb.
2. Cut out template where marked and align top
of template with height line.
3. Ensure striker is facing right way up with
slotted screw hole to top.
4. Mark top screw hole, ensuring it is in centre of
closing jamb (use centre line marked on template).
5. Fit striker using top screw only.
Close door slowly to check that
striker lines up with lock.
Adjust if necessary then fit bottom
screw.
On timber jambs you may mortice
the back of the striker into the closing
jamb to a depth of 3mm (1/8”).
IMPORTANT: THE CL100 IS NOT A DOOR STOP.
The door should be stopped in the correct closed position by the door stop, NOT the lock.
If the door’s momentum is not stopped by a closing jamb or an independent stop, long term damage may be done to the lock. To avoid this,
ensure the door hits the jamb or stop at the same time that the striker bottoms out on the faceplate of the lock.
ST
AGE
4
© All copyright and other property in this document is reserved by Cavity Sliders Ltd. Details and specifications are subject to change without notice. Whilst all care is taken to ensure the accuracy of all information, no
responsibility will be accepted for any errors or omissions. ® CAVILOCK is a Registered Trademark.
CAVILOCK® CL100 (O.D. 1994). 02.2018
csfordoors.co.nz • cavitysliders.com.au • cavitysliders.com
M4 x20mm
cap screw
M4 threaded plug