6–Boot from SAN Configuration
iSCSI Boot from SAN
79
AH0054602-00 J
8.
Select
iSCSI First Target Parameters
(
), and then press
ENTER.
Figure 6-12. System Setup: Selecting iSCSI First Target Parameters
9.
On the iSCSI First Target Parameters page, set the
Connect
option to
Enabled
for the iSCSI target.
10. Type values for the following parameters for the iSCSI target, and then press
ENTER:
IPv4* Address
TCP Port
Boot LUN
iSCSI Name
CHAP ID
CHAP Secret
NOTE
For the preceding parameters with an asterisk (*), the label will change
to
IPv6
or
IPv4
(default) based on IP version set on the iSCSI General
Parameters page, as shown in
.
