6–Boot from SAN Configuration
iSCSI Boot from SAN
84
AH0054602-00 J
Figure 6-16. System Setup: iSCSI General Parameters
Enabling CHAP Authentication
Ensure that the CHAP authentication is enabled on the target.
To enable CHAP authentication:
1.
Go to the iSCSI General Parameters page.
2.
Set
CHAP Authentication
to
Enabled
.
3.
In the Initiator Parameters window, type values for the following:
CHAP ID
(up to 255 characters)
CHAP Secret
(if authentication is required; must be 12 to 16
characters in length)
4.
Press ESC to return to the iSCSI Boot Configuration page.
5.
On the
iSCSI Boot Configuration Menu
, select
iSCSI First Target
Parameters
.
6.
In the iSCSI First Target Parameters window, type values used when
configuring the iSCSI target:
CHAP ID
(optional if two-way CHAP)
CHAP Secret
(optional if two-way CHAP; must be 12 to 16 characters
in length or longer)
