6–Boot from SAN Configuration
iSCSI Boot from SAN
92
AH0054602-00 J
Configuring the iSCSI Targets
You can set up the iSCSI first target, second target, or both at once.
To set the iSCSI target parameters on Windows:
1.
From the Main Configuration page, select
iSCSI Configuration
, and then
select
iSCSI First Target Parameters
.
2.
On the iSCSI First Target Parameters page, set the
Connect
option to
Enabled
for the iSCSI target.
3.
Type values for the following parameters for the iSCSI target, and then press
ENTER:
IPv4* Address
TCP Port
Boot LUN
iSCSI Name
CHAP ID
CHAP Secret
4.
If you want to configure a second iSCSI target device, select
iSCSI Second
Target Parameters
), and enter the parameter
values as you did in
. This second target is used if the first target
cannot be connected to.Otherwise, proceed to
5.
In the Warning dialog box, click
Yes
to save the changes, or follow the OEM
guidelines to save the device-level configuration.
Detecting the iSCSI LUN and Injecting the QLogic Drivers
1.
Reboot the system, access the HII, and determine if the iSCSI LUN is
detected. Issue the following UEFI Shell (version 2) script command:
map -r -b
NOTE
For the preceding parameters with an asterisk (*), the label will change
to
IPv6
or
IPv4
(default) based on IP version set on the iSCSI General
Parameters page, as shown in
.
