6–Boot from SAN Configuration
FCoE Boot from SAN
119
AH0054602-00 J
Figure 6-31. System Setup: FCoE Mode Enabled
To configure the FCoE boot parameters:
1.
On the Device UEFI HII Main Configuration Page, select
FCoE
Configuration
, and then press ENTER.
2.
On the FCoE Configuration Page, select
FCoE General Parameters
, and
then press ENTER.
3.
On the FCoE General Parameters page (
), press the UP
ARROW and DOWN ARROW keys to select a parameter, and then press
ENTER to select and input the following values:
Fabric Discovery Retry Count
: Default value or as required
LUN Busy Retry Count
: Default value or as required
