14–Windows Server 2016
Configuring RoCE Interfaces with Hyper-V
239
AH0054602-00 J
Creating a Hyper-V Virtual Switch with an RDMA NIC
Follow the procedures in this section to create a Hyper-V virtual switch and then
enable RDMA in the host VNIC.
To create a Hyper-V virtual switch with an RDMA virtual NIC:
1.
On all physical interfaces, set the value of the
NetworkDirect Functionality
parameter to
Enabled
.
2.
Launch Hyper-V Manager.
3.
Click
Virtual Switch Manager
).
Figure 14-1. Enabling RDMA in Host Virtual NIC
4.
Create a virtual switch.
5.
Select the
Allow management operating system to share this network
adapter
check box.
In Windows Server 2016, a new parameter—Network Direct (RDMA)—is added in
the Host virtual NIC.
To enable RDMA in a host virtual NIC:
1.
Open the Hyper-V Virtual Ethernet Adapter Properties window.
2.
Click the
Advanced
tab.
