265
83840-546-00 N
18
Running User Diagnostics
in DOS
This chapter covers the following for user diagnostics in MS-DOS:
“Performing Diagnostics” on page 265
“Diagnostic Test Descriptions” on page 268
Introduction
Cavium 8400/3400 Series User Diagnostics is an MS-DOS based application that
runs a series of diagnostic tests (see
) on the Cavium 8400/3400 Series
network adapters in your system. Cavium 8400/3400 Series User Diagnostics
also allows you to update device firmware and to view and change settings for
available adapter properties.
To run Cavium 8400/3400 Series User Diagnostics, create an MS-DOS 6.22
bootable disk containing the
uediag.exe
file. Next, start the system with the
“Performing Diagnostics” on page 265
for additional
instructions on running diagnostic tests on Cavium network adapters.
System Requirements
Operating System: MS-DOS 6.22
Software:
uediag.exe
Performing Diagnostics
At the MS-DOS prompt, type
uediag
followed by the command options.
lists the
uediag
command options. For example, to run all diagnostic
tests on adapter #1 except Group B tests, issue the following command:
C:\>
uediag -c 1 -t b
