9–Configuring iSCSI Protocol
iSCSI Boot
87
83840-546-00 N
To configure the iSCSI boot parameters using static configuration:
1.
On the
Main Menu
, select
iSCSI Boot Configuration
(
), and then
press ENTER.
Figure 9-5. Selecting iSCSI Boot Configuration
2.
On the
iSCSI Boot Main Menu
, select
General Parameters
),
and then press ENTER.
Figure 9-6. Selecting General Parameters
3.
On the
General Parameters Menu
, press the UP ARROW or DOWN
ARROW keys to select a parameter, and then press the RIGHT ARROW or
LEFT ARROW keys to set the following values:
TCP/IP Parameters via DHCP
: Disabled (IPv4)
IP Autoconfiguration
: Disabled (IPv6)
iSCSI Parameters via DHCP
: Disabled
CHAP Authentication
: As required
Boot to iSCSI Target
: As required
DHCP Vendor ID
: As required
Link Up Delay Time
: As required
Use TCP Timestamp
: As required
Target as First HDD
: As required
LUN Busy Retry Count
: As required
IP Version: As Required
(IPv6, non-offload)
