9–Configuring iSCSI Protocol
iSCSI Boot
89
83840-546-00 N
7.
On the
1st Target Parameters Menu
, enable
Connect
to connect to the
iSCSI target. Type values for the following parameters for the iSCSI target,
and then press ENTER:
IP Address
TCP Port
Boot LUN
iSCSI Name
CHAP ID
CHAP Secret
8.
To return to the
iSCSI Boot Main Menu
, press ESC.
9.
If you want configure a second iSCSI target device, select
2nd Target
Parameters
, and enter parameter values as you did in
. Otherwise,
proceed to
10. Press ESC one time to return to the main menu, and a second time to exit
and save the configuration.
11.
Select
Exit and Save Configurations
to save the iSCSI boot configuration
(
). Otherwise, select
Exit and Discard Configuration
. Press
ENTER.
Figure 9-7. Saving the iSCSI Boot Configuration
12. After all changes have been made, press CTRL+ALT+DEL to exit CCM and
to apply the changes to the adapter’s running configuration.
NOTE
In NPAR mode, ensure that the iSCSI function is configured on the first
physical function (PF) for successful boot from SAN configuration.
