6–Linux Driver Software
Setting Values for Optional Properties
45
83840-546-00 N
ooo_enable
The
ooo_enable
(enable TCP out-of-order) parameter feature enables and
disables TCP out-of-order RX handling feature on offloaded iSCSI connections.
Default: TCP out-of-order feature is ENABLED. For example:
insmod bnx2i.ko ooo_enable=1
or
modprobe bnx2i ooo_enable=1
bnx2fc Driver Parameters
Supply the optional parameter
debug_logging
as a command line argument to
the insmod or modprobe command for bnx2fc.
bnx2fc_debug_logging
The bit mask to enable debug logging enables and disables driver debug logging.
Default: None. For example:
insmod bnx2fc.ko debug_logging=0xff
or
modprobe bnx2fc debug_logging=0xff
I/O level debugging =
0x1
Session level debugging =
0x2
HBA level debugging =
0x4
ELS debugging =
0x8
Misc debugging =
0x10
Max debugging =
0xff
cnic Driver Parameters
To set the qcnic driver parameters, issue one of the following commands:
#esxcli system module parameters set -m qcnic -p Param=Value
#esxcfg-module -s <param>=<value> qcnic
cnic_debug
The
cnic_debug
parameter sets the driver debug message level. Valid values
are in the range of
0h–8000000h
. The default value is
0h
.
