7–iSCSI Configuration
Configuring iSCSI Boot
88
AH0054602-00 A
Figure 7-15. Dell System Setup: iSCSI General Parameters
Enabling CHAP Authentication
Ensure that the CHAP authentication is enabled on the target.
To enable CHAP authentication:
1.
Go to the iSCSI General Parameters page.
2.
Set
CHAP Authentication
to
Enabled
.
3.
In the Initiator Parameters window, type values for the following:
CHAP ID
(up to 255 characters)
CHAP Secret
(if authentication is required; must be 12 to 16
characters in length)
4.
Press ESC to return to the iSCSI Boot configuration page.
5.
On the iSCSI Boot configuration page, select
iSCSI First Target
Parameters
.
6.
In the iSCSI First Target Parameters window, type values used when
configuring the iSCSI target:
CHAP ID
(optional if two-way CHAP)
CHAP Secret
(optional if two-way CHAP; must be 12 to 16 characters
in length or longer)
