123
AH0054602-00 A
9
iWARP Configuration
Internet wide area RDMA protocol (iWARP) is a computer networking protocol
that implements RDMA for efficient data transfer over IP networks. iWARP is
designed for multiple environments, including LANs, storage networks, data
center networks, and WANs.
This chapter provides instructions for:
Configuring iWARP on Windows
This section provides procedures for configuring iWARP through HII, enabling
iWARP and verifying RDMA, and verifying iWARP traffic.
To configure iWARP through HII:
1.
Access the Dell System Setup, and then click
Device Settings
.
2.
On the Device Settings page, select a port for the 25G 41
xxx
Series
Adapter.
3.
On the Main Configuration Page for the selected adapter, click
NIC
Configuration
.
4.
On the NIC Configuration page (
a.
Set the
NIC + RDMA Mode
to
Enabled
.
b.
Set the
RDMA Protocol Support
to
iWARP
.
NOTE
Some iWARP features may not be fully enabled in the current release. For
details, refer to
Appendix D Feature Constraints
.
