10–SR-IOV Configuration
Configuring SR-IOV on VMware
146
AH0054602-00 A
d.
Click
Finish
.
Figure 10-14. Add New Virtual Hardware
15. Power on the VM and then issue the following command:
check lspci -vv|grep -I ether
16. If no inbox driver is available, install the driver.
17. As needed, add more VFs in the VM.
Configuring SR-IOV on VMware
To configure SR-IOV on VMware:
1.
Access the Dell System Setup, and then click
System BIOS Settings
.
2.
On the System BIOS Settings page, click
Integrated Devices
.
3.
On the Integrated Devices page (see
):
a.
Set the
SR-IOV Global Enable
option to
Enabled
.
b.
Click
Back
.
4.
On the Dell System Setup window, click
Device Settings
.
5.
On the Device Settings page, select a port for the 25G 41
xxx
Series
Adapter.
6.
On the Device Level Configuration (see
a.
Set the
Virtualization Mode
to
SR-IOV
.
b.
Click
Back
.
7.
On the Main Configuration Page, click
Finish
.
