3–Driver Installation
Installing Windows Driver Software
24
AH0054601-00 B
b.
Place the extracted individual files in a temporary folder.
3.
To use Microsoft's pnputil tool to upgrade or install the QLogic drivers:
a.
Copy the QLogic driver files to the Nano Server.
b.
After creating a Nano Server image, mount it, and copy over the files.
c.
Navigate to the QLogic driver directory, and issue the following
command:
pnputil /add-driver c:\drivers\*.inf /install
4.
To run the Firmware Upgrade Utility in a Nano Server environment:
a.
Copy the utility into the Nano Server.
b.
After creating Nano Server image, mount it, and copy the utility.
c.
After connected remotely, navigate to the utility directory, and then run
the utility.
NOTE
You will use the QLogic drivers files during Nano Server image
creation. For more information on a specific command, refer to the
Injecting Drivers
section in the Microsoft link noted in
NOTE
The QLogic drivers were copied to the
c:\drivers
folder in the
preceding command.
NOTE
For more information on connecting remotely to a Nano Server,
refer to the
Using Windows PowerShell
section in the Microsoft
link noted in
