5–Adapter Preboot Configuration
Getting Started
38
AH0054601-00 B
Setting the
Partitioning Mode
to
NPAR
adds the
Partitions
Configuration
option to the Main Configuration Page, as shown in
.
Figure 5-4. Main Configuration Page, Setting NPAR Partitioning Mode
and , the Main Configuration Page shows the following:
Firmware Image Properties
“Displaying Firmware Image Properties”
Device Level Configuration
(see
“Configuring Device-level Parameters” on
)
Port Level Configuration
(see
“Configuring Port-level Parameters” on
)
iSCSI Configuration
(if iSCSI remote boot is available) (see
FCoE Configuration
(if FCoE boot from SAN is available) (see
Partitions Configuration
(if
NPAR
is selected as the
Partitioning Mode
)
“Configuring Partitions” on page 51
In addition, the Main Configuration Page presents the adapter properties listed in
Table 5-1. Adapter Properties
Adapter Property
Description
Partitioning Mode
Default
or
NPAR
Device Name
Factory-assigned device name
Chip Type
ASIC version
PCI Device ID
Unique vendor-specific PCI device ID