5–Adapter Preboot Configuration
Configuring Partitions
54
AH0054601-00 B
4.
When prompted, click
Yes
to save the changes. Changes take effect after a
system reset.
To configure partitions:
1.
To examine a specific partition configuration, on the Partitions Configuration
page (
), select
Partition
n
Configuration
.
2.
To configure the first partition, select
Partition 1 Configuration
to open the
Partition 1 Configuration page (
), which shows the following
parameters:
Personality
NIC Mode
(always enabled)
PCI Device ID
PCI
(bus)
Address
Permanent MAC Address
Virtual MAC Address
Partition 1 is always present and cannot be disabled.
Figure 5-18. Partition 1 Configuration
3.
To configure the second partition, select
Partition 2 Configuration
to open
the Partition 2 Configuration page. If FCoE Offload is present, the Partition 2
Configuration shows the
Personality
as
FCoE
) and the
following additional parameters:
NIC Mode
(
Disabled
)
FCoE Offload Mode
(
Enabled
)
FCoE
(FIP)
MAC Address
Virtual FIP MAC Address
World Wide Port Name
Virtual
World Wide Port Name
