Screw the mounting base on the ceiling.
Screw the power supply on the mounting base.
Once the mounting base with power supply is
installed, attach the alarm by twisting clockwise
until it clicks. If the battery is either missing or
inserted incorrectly, the smoke alarm will not be
able to click into the mounting base.
OPTION 2:
ALARM MOUNTED ON TOP OF
CONDUIT BOX:
Connect the 3 wires from the conduit box on the
alarm power supply:
Live feed (L1), neutral (N), Ground ( ).
Screw the power supply on conduit box.
NOTE: Mounting base is not used when
the alarm is installed on conduit box.
OPTION 3
: ALARM MOUNTED WITH LAMP
SOCKET:
Drill through the middle of the alarm (Diam. 8mm)
Install the power supply into the mounting base
ring or use the conduit box as shown in option
1 & 2.
NOTE: Alarm supply must be different from the
lamp supply which can be switched ON and OFF.
Remove the plastic cover to access to the power
supply connector.
Pass the lamp wire through the smoke alarm.
5.
INSTALLING THE SMOKE ALARM:
NOTE: THIS ALARM NEEDS TO BE INSTALLED
BY A PROFESSIONAL.
MAKE SURE ELECTRICITY IS SWITCHED OFF
BEFORE STARTING THE INSTALLATION.
CAUTION: LIVE, NEUTRAL AND EARTH MUST
BE CORRECTLY INSTALLED AND NOT MIXED UP.
NOTE: The alarm is delivered in the packaging
with a dust cover, installed to protect the alarm for
exposure to excessive dust which could potentially
damage or reduce the function of the alarm while
the building is under construction. The dust cover
must be removed after the building is fully cleaned.
OPTION 1:
ALARM MOUNTED ON MOUNTING
BASE OUT ON THE CEILING:
Use the mounting base ring to mark the screw
holes on the ceiling.
For surface wiring pass the feed wire through
the mounting base cable holder and screw after
termination.
Connect the 3 wires to the power supply: Live feed
(L1), neutral (N), Ground ( ).
MARK UP
4 SCREW HOLES
WITH A PEN
L1
N
N
L1 L2
L1
N
N
L1 L2
2
USE THE
ENCLOSED
SCREWS AND
PLUGS
