background image

•  The luminaire and heat alarm must be installed in accordance 

with local wiring regulations if in doubt seek advice from a 
qualified electrician. 

•  Before installing or completing maintenance work on the 

luminaire and heat alarm make sure the mains power 
is switched off. 

•  The luminaire and heat alarm is designed for indoor use only. 
•  The luminaire is dimmable, a trailing-edge dimmer must be 

used. 

•  The light source of this luminaire is not replaceable; when the 

light source reaches its end of life the whole luminaire must 
be replaced. 

•  The luminaire is fire rated 30/60/90 minutes under 

EN1365- 2014 fire test. 

•  The driver provided is the only driver that can be used with 

this luminaire.

•  The heat alarm can only be installed within the Lumi-Plugin 

luminaire and not as a single unit. 

•  The heat alarm is powered by mains power (110-230V AC), 

with a CR2 lithium back-up battery. 

•  The heat alarm can be RF interlinked with other alarms in the 

CAVIUS Wireless Family.

•  The Maximum number of alarms that can be interlinked within 

a house group is 32. 

•  The distance between interlinked alarms depends on the house 

layout and should always be tested after installation. It is not 
advised to install alarms with a separation of more than 10m.

• 

The best areas to install the heat alarms:  

•  Areas not suitable for smoke alarms due to high risk of 

false alarms

•  Kitchen area
• Bathroom
•  Garage or workshop

•  Do not install the heat alarms: 

•  In rooms where the temperature goes 

outside -10

o

C to +50

o

C. 

• Bedrooms
• Lounge
•  Dining room 
• Hallway
•  Family room

Installation and Specification Sheet 

LP120 Main Powered Heat Alarm Downlight 

Brand: 

Lumi-Plugin 

Available Colours: 

White or Chrome 

IP Rating: 

IP65 

Material: 

Mixed (Metal and Plastic) 

Input Voltage to luminaire 

16V 

Input Voltage to Driver 

220V - 240V 50/60Hz 

Power Output: 

9.5W 

Colour Temp: 

4000K or 2700K 

Light Colour: 

Cool White or Warm White

Dimmable: 

Yes 

Fire Rating: 

30/60/90 

Luminaires per pack: 

Product Diameter: 

120mm 

Product Depth: 

70mm 

Hours: 

50,000 

Lumens: 

700L 

Beam Angle: 

60° 

Brand: 

Lumi-Plugin 

Battery Type:

Replaceable CR2

Operation AC/DC: 

110V AC, 230V AC

Range:

Minimum 100m in open field

Power Consumption:

161mAh in non-alarm condition

Interlink Frequency:

868MHZ

Sound:

Audible indicator min 85dB @ 3 
meter in anechoic successive tones 

5 Year  

Warranty

5

50,000  

Hours

16V

CE Mark

Beam Angle 

is 60°

Fire Rated 

30/60/90

Dimmable

700  

Lumens

Driver  

Included

LP120WH/WARM/MBR/HA - LP120WH/COOL/MBR/HA

Summary of Contents for LUMI-PLUGIN LP120

Page 1: ...lways be tested after installation It is not advised to install alarms with a separation of more than 10m The best areas to install the heat alarms Areas not suitable for smoke alarms due to high risk of false alarms Kitchen area Bathroom Garage or workshop Do not install the heat alarms In rooms where the temperature goes outside 10o C to 50o C Bedrooms Lounge Dining room Hallway Family room Inst...

Page 2: ...using magnets The alarm comes with a cable fitted Ensure the cable is coming out of the back of the luminaire and connect to the mains power 5 Lift both springs so they are in the upwards position then insert the luminaire into the 92mm cut out hole in the ceiling Make sure no cables are trapped under the springs and that the luminaire is centred in the hole Please note The alarm is delivered in t...

Page 3: ...uminaires Changing the heat alarm battery 1 Pull down the heat alarm so the magnets are not connected to the luminaire Diagram 5 2 Twist the heat alarm anti clockwise to release the alarm from the mains power 3 On the back of the alarm remove the cap over the battery Diagram 8 4 Remove the battery and replace with a new battery Diagram 9 Please note You will not be able to install the heat alarm w...

Page 4: ...o locate the source of the alarm before using the hush function This is to make sure that it is not a life threatening situation Low battery signal Your product has a battery back up with a 1 year life in battery mode without mains power and up to 10 years normal life with mains However we recommend to replace the battery every 5 years When the battery is starting its end of life a short beep will...

Reviews: