Press the Power Switch (POWER) on the front panel, the unit will firstly execute
closing disc tray, the display will show
Reading TOC
, and the unit will do
selfcheck.
Turning on/off the unit
V
OPERATION
1.Press the Open/Close Button on the front panel or the Open/Close Button on the
Remote Control Unit, the Disc Tray slides out.
2.Place the compact disc in the Disc Tray label-side up.
3.Press the Open/Close Button on the front panel or the Open/Close Button on the
Remote Control Unit, the Disc Tray is closed.
4.After the Display indicates the number of tracks on the disc and the total time of
the disc, press the Play/Pause Button on the front panel or the
Button on the
Remote Control Unit to start playing the disc.
If the Disc Tray is open when you press the Play/Pause Button (or
Button), it
will close automatically and start playing.
Normally, the disc will start playing with the first track. However, you can select
a different track using the Skip Buttons or the Number Buttons to start playing a
different selection.
Playback
During playback or in PAUSE mode, press the Stop Button on the front panel or
the Stop Button on the Remote Control Unit to stop a disc that is playing and resets
the player.
Stop
During playback, press the Play/Pause Button on the front panel or the
Button
on the Remote Control Unit to interrupt the playback temporarily.
Press the Play/Pause (or
) Button again to resume playback from the position
where PAUSE mode was entered.
Even when the player is in PAUSE mode, the disk motor is still revolving. Since
leaving the player in this condition can shorten the lifetime of the motor, do not
leave the player in PAUSE mode for a long period of time.
Pause
During playback or in STOP mode, you can select a track to play using the Skip
(
and
) Buttons or the Number Buttons (Remote only).
Using the Skip Buttons
Press the
Button
advance the beginning of the next track. If the current
track is the last track, press this button advances to the beginning of the first track.
Track Search
to
5
Do not place any obstacles between the Remote Control Unit and the Remote
Sensor.
Do not expose the Remote Sensor to strong light.
