CB Tech CB-As, Installation Manual

Below Sink Kit Components

1. 

Connect the included Inlet adapter (MC738) to the system housing’s 
labeled  Inlet  port.  Rotate  the  adapter  clockwise,  first  by  hand,  then 
using a wrench, to tighten onto the system.

2. 

Connect the included Outlet adapter (MC741) to the system housing’s 
labeled Outlet port. Rotate the adapter clockwise, first by hand, then 
using a wrench, to tighten onto the system.

Connect Tubing to the Outlet Port

1. 

Using wire cutters or a knife, cut 
(square cut) the tip end off of the 
blue plastic tubing (either connected 
to the faucet or a separate piece 
included with the Capacity Monitor). 
Do not use scissors.

2. 

Fully insert the tubing into the adapter 
on the OUTLET port of the system 
housing; the tubing should be inserted 5/8” into the adapter.

NOTE: When pushing the tubing into the adapter, you will encounter 
some resistance. This does not mean that the tube is fully inserted. 
Continue  to  push  firmly  until  the  tubing  is  inserted  as  far  as  possible 
(roughly 5/8” into the adapter).

3. 

Pull on the tubing to make sure that it is securely connected.

Connect Tubing to the Inlet Port

1. 

Using wire cutters or a knife, cut 
(square cut) the tip end off of the 
clear plastic tubing connected to the 
Adapta Valve. Do not use scissors. Do 
not cut more than 1/2” off of the end 
of the clear plastic tubing.

Connect the Tubing to the Housing

14

blue tubing

insert

OUTLET

adapter

INLET

adapter

clear tubing

insert