3
2
I
MPORTANT
Installation should be performed by a qualified service person and conform
to all local codes.
D
ESCRIPTION
Model ZC-OH2 is a tamper resistant indoor or outdoor housing which is
designed to accommodate all CBC ZC series minidome cameras. This
housing will accept the following cameras:
Model ZC-D1024EHA
Hi-Res B/W Camera with 2-4mm A/I varifocal
Model ZC-D1036EHA
Hi-Res B/W Camera with 3-6mm A/I varifocal
Model ZC-D1049EHA
Hi-Res B/W Camera with 4-9mm A/I varifocal
Model ZC-D2550EHA
Hi-Res B/W Camera with 5-50mm A/I varifocal
Model ZC-D1024NHA
Hi-Res Color Camera with 2-4mm A/I varifocal
Model ZC-D1036NHA
Hi-Res Color Camera with 3-6mm A/I varifocal
Model ZC-D1049NHA
Hi-Res Color Camera with 4-9mm A/I varifocal
Model ZC-D2550NHA
Hi-Res Color Camera with 5-50mm A/I varifocal
M
AJOR
F
EATURES
•
Polycarbonate dome with rugged cast aluminum housing withstands the
blow from a 10 pound sledgehammer
•
O-Ring Sealed housing is completely air-tight and water-tight (when
properly installed) and is suitable for virtually any weather condition
•
Quick and easy installation utilizing 8 different dome camera options
•
Housing mounts directly to any wall, ceiling or 4S Electrical box
•
Interchangeable dome with tinted, gold and chrome options
I
NSTALLATION
1) Standard Housing Installation
a) Caution: Do Not Remove Screws. Loosen the 3 set screws
from the dome base using the supplied allen key and remove the
dome cover. the O-Ring makes a tight seal, so a thin-bladed screw-
driver may be needed to separate the dome cover from the housing
base.
b) Remove the rubber plugs from the mounting holes inside the base.
Remove only those plugs for the mounting holes that will be used.
c) Using a minimum 7/32” drill bit, drill the cable feed hole and feed the
video/power cable through the mounting surface.
d) Holding the dome against the mounting surface, mark and drill the 4
mounting holes. Fasten the base to the mounting surface using the
supplied #8 Phillips screws, rubber washers and plastic anchors. Be
sure to re-install the rubber plugs into any unused mounting holes.
(Depending on the mounting surface, other hardware may be
needed.)
Note: (If using other mounting hardware)
To prevent damage from leakage, apply silicone sealant
around the inside of the 4 mounting holes before inserting
screws or bolts.
2) Optional Conduit Base Installation (Model ZC-CB2)
a) Install optional conduit base using supplied screws and anchors or
other hardware. Apply a bead of silicone sealant between the base
and mounting surface.
b) Route conduit to base and inset into conduit hole. Lock down the
conduit end with allen head set screw.
c) Feed the power/video cable from the housing base to the loose
wires from the conduit. It may be necessary to shorten the
power/video cable so that all of the spliced connections fit within the
center of the conduit base.
e) Making sure all the connections are tucked into the center of the
conduit base, install the housing base to the conduit base using the
supplied 4 machine screws. Apply a bead of silicone sealant between
the housing base and conduit base.
